SPECIFICATIONS FOR JN01S
Model |
Wire Size |
||||||||||
AWG |
UL1007 |
#30 |
#28 |
#26 |
#24 |
#22 |
#20 |
#18 |
#16 |
#14 |
|
mm2 |
0.05 |
0.08 |
0.12 |
0.2 |
0.3 |
0.5 |
0.85 | 1.25 |
2.0 |
||
| JN01S-FX30 |
|
Max outer dia. of wire should be up to Ø1.4 |
|||||||||
| JN01S-FN |
|
Max outer dia. of wire should be up to Ø1.8 |
|||||||||
| JN01S-ST |
|
Max outer dia. of wire should be up to Ø3.5 |
|||||||||
| Model | JN01S-FX30 | JN01S-FN | JN01S-ST |
| Function | Measuring-Cutting-Both end stripping-Both end crimping-Auto-blade depth adjustment-Auto-crimping position adjustment - Auto-strip length adjustment - Both end half-strip - Wire falling device on No.1 & No.2 crimping - Step driving | ||
| Capacity | 1.0 sec/pc (in case of min. wire length) | 0.85 sec/pc (in case of min. wire length) | |
| Wire Size | 0.05~0.2mm2 (AWG#30~#24 UL1007 equivalent) call Toyojamco in case of special wire - UL1571 stranded many wires. | 0.12~0.5mm2 (AWG#26~#20 UL1007 equivalent) call Toyojamco in case of special wire | 0.3~2.0mm2 (AWG#22~#14 UL1007 equivalent) call Toyojamco in case of special wire |
| Cutting Length | 35~5,000mm (9,999mm) - Cutting length depends on pre-feeder type | ||
| Cutting Accuracy | Variation within 1mm+ (set length x 0.002) | ||
| Stripping Length | No. 1 side: 1.5~17mm (half-strip max. 35mm) | ||
| Cut Depth | 2mm (100 STEP: 1 STEP=0.02mm) - Max Adjustment 2mm | ||
| Press Capacity | 19,600N (2 TON x 2) low noise type | ||
| Detector | Low air pressure - Crimping miss - Wire stripping miss - Abnormal action of wire reel stand | ||
| Power Source | AC200V (within ± 10%) 50/60Hz single phase 7A | ||
| Compressed Air | 0.5Mpa (5kgf/cm2) approx. 280NL/min (use clean dry air) | ||
| Temperature | 15~25°C (Circumstances) 30~80%RH (Humidity) | ||
| Dimension/Mass | 1,100W x 670D x 1,450H (mm) - (approx. 450kg) | ||
| Option | Wire reel stand (bundle, reel) - Wire pre feeder (2m, 5m) - Paper winding unit - Belt chute - Wire joint detector - Manual crimp height device - Simplified crimp pressure control device - Central control system - Servo crimper (19600N) - Auto-crimp height device (designing) - Multi reel stand - Inferior products selection device (cannot be set at customer plant) - Terminal presence - Guide plate with terminal overload | ||
| Special Option | FNASY, STASY, soft wire | FX-30ASY, STASY | FX-30ASY, FNASY, big wire |